CMM Sets contain Spring Clamps with fast trigger – action, non-marring, low-profile. Includes:
Cross-Bow™; Trigger-Block™; D-Block™; Spring-Loc™; Trigger-Finger™ with Shaft; Trigger-Point™ with Shaft;

See Risers & Stand-Offs for additional Shafts;
See Stops & Rails for Hole Adjusters with Thumb Screws.

  • Spring-loc-dimsNew Products

    Low-profile spring steel clamps -Metric (Set of 2)

    The Spring-Loc™ is an extremely low profile (1.83mm) clamp capable of producing approximately 10 lbs. of clamping pressured depending on how much the flex arm is compressed in the locked position. The clamp center slot allows 360° positioning. The back end of the Spring-Loc™ is “V” shaped allowing customers to run parts in series or back to back for engraving, laser etching and provides a simple and quick method for locating and holding parts for CMM and Vision Systems


  • Trigger-Finger Low top view single

    TRFN-10M

    Individual plastic Trigger-Finger™ hold downs to add to your shafts.


  • triggerpoint-mTrigger-Point & Steel shaft - set of 4 ea

    The Trigger-Point™ spring-steel tipped hold down provides pin-point hold down pressure. Includes 3 tips: 1 ea. 15°, 1 ea. 90°, and 1 straight to be customized.  Set of 4

    TRPT-20M


  • crossbowCross-Bow clamps

    Cross-Bow™ Set of  8 spring blocks – Metric version Cross-Bow™ spring clamps hold pieces in place quickly and securely.


  • dblock-m

    The gripping edge of the D-Block™ works like a spring to secure and release your work. Parts are held with plenty of force for measuring and with a squeeze of the trigger a part can be quickly released and replaced. Part change-over is one-handed with no need for tools and tape.


  • Trigger-Block, Metric- set of 2Trigger-block clamps set of 6

    Productivity improvements are achieved by the unique design – the gripping edge of the Trigger-Block™ works like a trigger or spring to secure and release your work. Parts are held with plenty of force for measuring and with a squeeze of the trigger a part can be quickly released and replaced. Part change-over is one-handed with no need for tools and tape.


  • Trigger-Finger Tall setup on 6x6IMG_1475

    The gripping edge of the Trigger-Finger™ works like a spring to secure and release your work.  Parts are held with plenty of force for measuring and with a squeeze of the trigger a part can be quickly released and replaced. Part change-over is one-handed with no need for tools and tape.